How To Clean a Bathroom Frazzle Fan

Hither'southward the plan — don't neglect the fan.

Time

An hour or less

Complexity

Beginner

Cost

Less than $20

Introduction

That little fan in the celling is more than of import than you might think. It helps get rid of odors, airborne contaminants and moisture in the air. A fan covered in dust doesn't work efficiently, eventually leading to mold, mildew and possibly a house burn. Requite it a skillful cleaning about every six months. Read on to find out how to clean your bath exhaust fan.

Tools Required

Materials Required

  • Microfiber towel

Project pace-past-footstep (5)

Step one

Remove the Vent Cover

  • Showtime, be sure the power is turned off to the fan. To be actress safe, turn off the excursion at the breaker box.
  • If it'southward just a vent with no low-cal, remove the vent encompass by gently pulling down on it, then squeezing the metallic mounting wires together on both sides. Slide them out of their slots, removing them from the fan housing.
  • If your vent cover has a light, disconnect the wire start. Printing the release tab on the connector before removing the embrace.

exhaust fan open

Step 2

Clean the Vent Embrace

  • Cleaning a cover without a light is simple. Make full your bathroom sink with warm water and a few drops of dish lather. Soak the cover in the soapy h2o for a few minutes, and then scrub information technology with a cloth or castor. Place the cover on a towel and let it air dry while you motion on to the side by side stride — cleaning the fan.
  • If your fan cover has a calorie-free, do not submerge it in h2o . But vacuum off the grit, wipe it make clean with a damp cloth, then air dry out.

exhaust fan clean

Step three

Clean the Fan Without Removing the Motor

  • Utilise a vacuum with a scissure zipper to remove most of the grit. Then switch to a brush attachment for the fan motor components and fan housing. Maintain a calorie-free bear upon then yous don't impairment annihilation.
  • In one case you remove the dry dust, take a damp microfiber cloth and wipe down the fan components and housing. This should remove any remaining dirt.

exhaust fan being vacuumed

Step 4

Remove the Motor for Deep Cleaning

  • Don't exist afraid to further detach the fan. Depending on your make and model, merely two or 3 screws hold the fan motor in the housing. (A magnetic tip screwdriver works well for this.)
  • To remove the fan motor, brainstorm past unplugging the connector or plug that powers the fan.

exhaust fan

  • Next, remove the mounting screws that hold the motor to the housing. Recall to hold the motor with one hand while removing the last screw, so lower the motor from the housing.

exhaust fan

  • Vacuum the motor and/or take it exterior and blow the dust from the motor and fan blades with forced air. A pocket-sized, soft bristle brush works well to remove caked-on dust.

Exhaust fan

  • Requite the motor, fan blades and fan housing a good wipe down with a damp microfiber cloth before re-installing the motor back in the housing.

cleaning exhaust fan

Step five

Reassemble the Exhaust Fan

  • With a make clean fan and a cover looking similar new, it's fourth dimension to put the fan back together. If y'all removed the motor, your commencement step is to put it back in place and supercede the screws.
  • Next, plug in the fan. Then put the encompass back on by inserting the mounting wires back into their slots, then gently pushing the encompass into place.

putting together clean exhaust fan

Originally Published: January 20, 2022